 |
| TopTes PT199 Natural Gas Detector with Visual Alarm |
Gas Leak Detector, TopTes PT199 Natural Gas Detector with Sound and Light Alarm, Portable Gas Sensor to Locate Leak Sources of Combustible Gases (such as Methane, Propane) (2 Batteries Included) - Orange
- 【TopTes PT199 Flammable Leak Detector is suitable for LPG, methane, ethane, propane, butane, natural gas, gas, sewage, LNG, etc., accurately identifies leaks, reduces explosion hazards, makes complete and safe safety of Your family and possessions
- 【Sound and Light Alarm】The gas detector uses sound and light alarm, and the detection speed can reach 0.5 seconds. You will know that gas has been detected when the bar graph goes up and the detector beeps. The alarm will increase as the gas volume increases and the LCD screen will turn red when the gas concentration is high
- 【Battery included for ease of use】The TopTes PT199 comes with two AAA alkaline batteries, so you can set up the detector and start using it as soon as you receive it. System warm-up time is about 30 seconds. When the battery voltage is less than 2.4V, the low battery indicator lights up. Auto power off after 5 minutes of no operation or no gas detected
- Compact, pocket-sized design with a pen hook that allows you to put it in your shirt pocket. The texture and non-slip materials make it easy to grip. The gas detector can also be easily stored with the accompanying storage bag. It's a great tool for RV enthusiasts, DIY enthusiasts, gas appliance owners and more. Save hundreds of dollars on diagnostics or waste gas on undetected leaks
- 【What You Get】 PT199 Gas Leak Detector, 1 storage bag, 2 AAA batteries, 1 instruction manual. In addition to Amazon's excellent delivery service, we also offer 36-month after-sales service and lifetime technical support. If you have any questions or inquiries, please feel free to contact us
guidance
Q: How do I configure the detector to be ready for detection?
A: Turn it on and wait 30 seconds for it to heat up. Remember that preheating must be done in a known "clean" environment for accurate results.
Q: How do I know the sensitivity of the current detector?
A: When button S lights up, the detector is in high sensitivity mode; When the light of the S button is off, the detector is in the low sensitivity mode.
Q: Will the alert remain until the situation is resolved?
A: Yes, the alarm will continue until the flammable gas concentration falls below 5% of the lower explosive limit.
Q: To what extent does the detector detect gas leakage from a gas line?
A: Usually 1-5 cm depending on the severity and concentration of the air leak.
Q: Does this detect carbon monoxide?
A: No, only combustible gases. Carbon dioxide is a gas produced by combustion.
Q: Can the sensor be replaced?
A: We do not sell sensors individually. If you find that the sensor has stopped working within three years from the date of purchase, please contact us.
Q: What is the difference between a gas detector and a gas leak detector?
A: Continuous Gas Leak Detectors Gas detectors are used to monitor air conditions in large areas, but they cannot accurately identify leaks. Gas leak detectors are used to locate the source of a gas leak.
Q: Why is the screen off/can't start?
A: The first thing to check is that the battery is installed correctly (make sure both poles are correct). After that, check whether the battery voltage is sufficient, replace it with two new batteries, and check whether the detector is working normally. If the problem persists, please contact us to request an exchange.