 |
| ALMOCN 2PCS NRF24L01+PA+LNA Wireless Transceiver |
ALMOCN for Arduino 2 NRF24L01 + PA + LNA 2.4G 1100m Wireless Transceiver Module RF Transceiver Module with SMA Antenna
The host microcontroller can connect and configure nRF24L01 + via 4-pin SPI. The configuration data set can be accessed via SPI connection. Configurable parameters include frequency channels (125 optional channels), output power and data rate (data rate: 250 kbps, 1 Mbps, 2 Mbps).
The on-chip voltage regulator accepts a supply voltage of 1.9 to 3.6V. The device has a fault-tolerant 5V input and can connect the SPI pin directly to the ArduinoIDE (compatible).
Internal filtration can provide significant advantages in meeting RF regulatory standards. The radio in the device uses Gaussian Frequency Switched Modulation (GFSK) and Automatic Fast Gain Control (AGC).
The unit contains an IRQ (Interrupt Request) pin that can be used to remind the host's microcontroller (such as ArduinoIDE) that the host controller (such as ArduinoIDE) is idle when the device is receiving the transmission signal, which greatly saves the power consumption of the battery device.
 |
| ALMOCN 2PCS NRF24L01+PA+LNA Wireless Transceiver |
- The device has a fault-tolerant 5V input and can connect the SPI pin directly to the Arduino.
- NRF24L01 is a single chip wireless transmitter and receiver for global 2.4-2.5GHz ISM. Compatible with Arduino and Raspberry Pi.
- Range: Over 800 compact sizes that easily fit any product in the smallest of spaces.
- NRF24L01 + high performance wireless data transmission chip with additional high performance PA and LNA chips, RF switches, band-pass filters and two-way RF power amplifiers, greatly expanding the effective communication distance.
- Applications: wireless devices and remote control systems (such as RC vehicles and remote consumer electronics), wireless voice transmission (such as VoIP), wireless sensor networks, wireless networks, home and professional automation.